Is there anybody here familiar with the q4 ECU.

I'm in a very difficult position. We were planning to remap the stock ECU entirely (with race2000). The changes on the car are as follows:

650cc injectors
3 bar MAP

However, with the standard resolution on the fuel table i find it very difficult to remap even on a dyno (we wasted 2 hours), because a lot of the table stays unused, and the entire boost range is located just in e couple of the top rows. I need to change the resolution of the fuel table, but the race2000 software has not this feature.

Another problem is, that with this map, the ECU tries to run in closed loop mode (lambda control) when in boost (something about 0.6 bar on part throttle) because of the changed MAP sensor.