Q4 vs. tipo camshaft

[djsly]

Left one: Q4 exhaust camshaft
Right one: Tipo exhaust camshaft




What I need?

To groove the line in Tipo's camshaft for tha camshaft sensor to fit in:




If any of you did it, how did you do it?

That's all that's left before putting the engine together.

thx for any suggestions.

djsly

[markgq4]

I have never done it, tho i am interested as well.

This man "wolf" has done it, see here :

http://www.berlinasportivo.com/phpBB...opic.php?t=180

near bottom of first page.

maybe he can help you out.

good luck.

[Stuntz]

Im interested in this as well . Wollf knows it but i think he is on holidays


P.S. praši wolfa sly al pa darko567 on more tud vedet je pa lepo slišat da se makina sestavla

[Juan AR155Q4]

You can send it to those guys who works with lathes and mills (sorry don't know the english word), surely they can easily do it.

BTW, I suppose you are also fitting Tipo's intake camshaft, don't you?
If I have no bad memory, the "magic" trick was to use Tipo's intake as Q4's intake and Q4's intake as Q4's exhaust.
Hope the last thing has been understood.

[djsly]

@juan: that's what i'm doing. Problem is that q4's intake doesn't have the place to put on the sensor

@mark: tnx, already contacted wolf, but he'll off work for whole month

@stuntz: wolf na dopustu, dare pa prav da ne dela tega Sej ni pene, bom probu sam narest ta teden...

[Juan AR155Q4]

Ok, I just was confused cause you said exhaust instead of intake.

Any machinery shop should do it. Take in care that the groove can't be done in any place. It must be done in a position closely to original. Remember the Hall sensor just tells the ECU when cylinder 1 is in compression.