Hi,

I am putting the gearbox back on the engine, I am doing this on the floor not in the car, I need to know how to definately get the clutch pull bit to line up and attach with the forks, I have tried it a couple of times to just push it together and hope for the best, it feels ok, like its making the correct contact but I need to be certain before the engine goes back in the car.

When I put it together I tried to turn the top lever using a ring spanner over the lever to move the clutch but it was too hard, should this be the case?

Cheers
Jack

p.s will post piccies later..


at last