Still having problem with the idle and would welcome your suggestions...
I need to check the MAP sensor pipe but not convinced that's at fault because it idles fine when warmer, after about five minutes.
Works done so far...
- water temp sensor replaced
- valve clearance set
- ICV cleaned...twice!
- found the source of the hissing (not inlet related)
- system appears to be without leaks
- new air filter
- new NGK BPR7EIX iridium plugs
I'm wondering about wear in the ICV and the measurement of the little nut on the end
Could it be my C&B inlet cam is causing the problem, idle when warm is still lumpy but I can't recall what it was like before?
Might look at replacing the plug leads...any other ideas?
wrinx
Bookmarks