Which wheels clear the calipers ?
Type: Posts; User: Leo; Keyword(s):
Which wheels clear the calipers ?
Hi Peter,
I have sent you a PM
Hi does anybody know if these as=re still available ?
Also anybody done any mods or upgrade at the gearbox end - my rubber bush is completely perished.
Leo
I was thinking the same thing ... They also have the cam sensor and twin coils
Ok but out of interest are there any ECU's which are interchangeable ?
OK Thanks - I was looking for a quick temporary fix
is it possible to switch ECU's ?
will a delta EVO 1 WH4W be replacement for a 4w6 ? Mine is a 101.02 and it seems to be creating problems for tuners
I took mine off ... Mainly on Guy Croft advise ... If the belt goes it will take out the cam belt. You make up little steel plates and it locks the shafts.
Hi Peter,
Thanks for your reply - I have fitted the Spax to the rear and the car seems good.
Leo
Thank you for this information
Thanks - There is no Fiat Part Number - but there is more lift than the stock cam - and my rough measurements came to around 0.5mm more than the standard stock cam so that seems to make sense.
Does anybody know what markings a Tipo 16v cam should have ? Mine is stamped A6 and has the numbers 466 as well as two painted bands one green and one yellow.
When I tried to measure it with...
I bought a used rack but after taking mine out I decided it was too risky and had the rack rebuilt. It's a big job and I didn't fancy doing it twice.
Thanks ... The drive would be difficult as the front is all dismantled ! I have the engine out now as I split the shaft at the uj. I think you are correct they seem glued or loctited on .
Just to show I'm not crazy !!
2396
Has anyone ever had a problem removing the props haft - I was expecting an easy job but cannot get it out - the cv joints seem to be stuck in the flanges - any ideas on freeing them off ?
Next to a proper bike I notice. :thumb:
Are these the exhaust manifold that proved to be no good for ours cars ?
...
Still thanks and that extra bit of information about reinforcing is good
That's great guys thanks for your help. Just ordered a coupe rack ... May need to change arms and track rod end but will see when I get it .... Looks a lot easier with the engine out if the way !...
I don't mind moving mounting point but is the gear linkage point the same ?
when I do the swap I will take photos and post here
thanks for this It's all confusing but helps :thumbsup:
Ok thanks so 155 2.0 16v is not a quick rack or doesn't fit ?
have you got a picture of how the linkage works ?