Printable View
Here is the movie of acceleration of my car from 0-150 km/h. Standing start is performed with light throttle not with clutch dump, which delivers best acceleration time (i felt pity for my gearbox on this one :D ).
http://www.mobisux.com/album/showpho...cat=500&page=2
Hi Wolf,
interesting video, would you mind if I copied this video up to the video section of the main website?
Steve
Not at all. I will post a video with clutch dump standing start and video from 0-200 km/h soon, if you are interested.
That would be great Wolf. Did the clutch survive?
I have new uprated clutch. I'm more worried about gearbox and differential, so i do it very rarely. Altough, with clutch dump my best acceleration time was 4.4 s from 0-100 km/h (measured with datalogger).
Thats pretty damn quick!! :cool:
Another movie with clutch dump and better acceleration time:
http://www.mobisux.com/album/showpho...cat=500&page=1
Did you get some clutch slip on that second video? Looked and sounded like you dumped the clutch, got some vibration, then a fraction of a second later the speedo started to move?
Oh and what clutch are you using, and what sort of power output is your car putting out?
No, there was no clutch slip. I revved the engine, then accidently slightly released the pedal, then pushed it again and dumped the clutch. Vibration occured, because i held the camera and steering wheel with one hand and i didn't firmly hold the camera.
I have sintered clutch (it is produced by local firm here in Slovenia http://www.sinter.si ). It should be easily capable of handling 500+ nm of torque.
I'm not sure about the power figure, because i didn't dynoed it yet. I run 1.5 bar boost @7000 RPM and my own developed chip. I think that power should be around 330 HP mark.