Well it broke, how or why, I have no idea. What would be the easyest way to replace it, possibly without removing all the parts from underneath the car that block the way to the metal thing that holds the gear lever?
Printable View
Well it broke, how or why, I have no idea. What would be the easyest way to replace it, possibly without removing all the parts from underneath the car that block the way to the metal thing that holds the gear lever?
Bad luck, can you get to it from the top inside the car if you take away all the trim?
You sure its not broken at the engine end?
Yes, I'm sure, if you are thinking about the connection to the gearbox, both cables are attached fine. Problem is I can't se any further from there.Quote:
Originally Posted by AlfaJack
I don't think it is possible, because of the central support, and the way it is configured. See picture: http://img223.imageshack.us/img223/1636/uzfufnk1.jpgQuote:
Originally Posted by AlfaJack
Another thing is that I have pulled the cable from the inside of the car, and as it comes out about 20 inches or so it blocks, and it won't go any further. If anyone has a picture of the engine bay without the engine, it would bi nice if they could post it, maybe I could get a better picture.
Is it broken from gearstick end?
I had this problem also and mine was just loosing one of the "holders". The holders are inside of gearstick hole. Hard to explain, but take out your gearstick cover and there you can see both of the cables.
I can get this from the hi res pics, but it wont be until later tonight unfortunately.Quote:
Originally Posted by veki
Best I can find for now:
http://www.cloverleaf4.co.uk/images/uploads/7123.jpg
That would be great, since I can't do much untill tomorrow anyway.
Thanx!
Sorry, even these are not that great but they might help a little.
Thank you very much, it is much clearer now. I'm pretty sure the problem is where the arrow is pointing. I'll get back with some details.
Thanx again.
Time to remove battery tray and get a torch and have a poke around :)
Got to the bottom of things, and here's what I found;
To be continued....
P.S. 155-tbo, whish it was as you said, but looks like it's going to be a bit more complicated.
Oh dear :( Have you sourced a new part?
Yes, about 115 € a piece. Best to change both while I'm at it, but I'll inspect the second one first.
Well, this took long enough...
So, I've managed to get it done without removing anything apart from the battery+holder, and some oil separator hoses. This is because the cable line (small bore hose through which the cable goes) remained in place. A few pics of the new cable below:
Nice, where did you source the parts?
p.s, congrats in the football!:tapedshut:
I had it made at a place that makes all sorts of cables. The ends are used from the old one, and the cable is new. When I pushed it through the line from the inside of the car and tightened the small screw to hold the cable, I pressed the iron end with big appliers so it would hold better. The whole thing cost me more than four times less than the original would, and time will tell how permanent of a solution it is.Quote:
Originally Posted by AlfaJack
Thanx, it really was special, I'm still ecstatic.Quote:
Originally Posted by AlfaJack
Perfect, good that it will last!