Remapping...

[cuore_sportivo_155]

I'm rebuilding my 2.0 8v engine, and after rebuilding the redline will move from 6200 RPM to 7000 RPM, rev limiter will cut in around 7200 RPM..

Question: with the standard ecu, can a chiptuner add another RPM breakpoint for the ignition timing since I will have almost 1000 RPM extra compared to a standard car... If not, would a megasquirt allow this, and can they cope with the twinspark system? The 8v fires both sparks at the same time, btw...

Regards,
cuore_sportivo_155

[Juan AR155Q4]

Surely an stand alone could do that, but if I'm not correct, you could change breakpoints (not adding) to reach those news 1000 rpms.

[cuore_sportivo_155]

so I'd have to make the breakpoints wider apart at low rpm so I can gain more precise ignition timing at high rpm? not really a problem since it's a track car but would prefer extra breakpoints :)

[Wolf66]

You can remove some breakpoints in lower RPM range as they are placed
close together. and add some at higher revs. I added new breakpoints
at 7000 and 7500 RPM in my car.

[cuore_sportivo_155]

cheers Wolf66 :) now I'll save up for an eprom reader/writer and some eproms... and look for "chiptuning for dummies"