PDA

View Full Version : Fuel Pressure gauge



Steve Webb
15-05-07, 19:35
Right, due to circumstances I need to hook up a fuel pressure gauge asap. From looking at the manual It seems to measure the fuel pressure you need to tap into the circuit at the point where the fuel hose joins the injector feed rail.
But the fuel pressure regulator is at the other end of the injector rail and the fuel pressure is measured without the engine running. So wouldn't the two ends of the fuel injector rail be at the same pressure?

I would attach the fuel pressure gauge in the recommended point but its a 14x1.5 thread and getting an adaptor might be a problem. The other end of the rail is just a push fit/jubilee clip affair.

Basically I just need to turn the fuel pressure down (and refit the Cats) to get the car through its CT (French MOT) then turn the fuel pressure back up after.

So will checking the pressure at the 'wrong end' matter?

Steve

Brul(tm)
15-05-07, 23:44
(French MOT)

I knew the French were difficult :roll:
Hope you get the car MOTed soon whitout any more difficulties
Good luck.

Greetings,
Marc

Wolf66
16-05-07, 09:32
You can measure it on the other end, where flexi hose from injector rail is attached to fuel pressure regulator. Just tap it in between this hose and fuel pressure regulator.

Steve Webb
16-05-07, 10:16
Cheers, just need to find a decent pressure gauge now.