PDA

View Full Version : Bracket design for engine stand?



#84
27-07-18, 13:10
The workshop manual recommends an engine stand which connects from both left and right side of the engine block - which I don't have. However on Scara 73 web page, it looks like they manage it from one side (http://www.scara73.com/web1/en/alfa-romeo/1746-155/motore/2199-2-0-t-16v-engine-preparation-2), even though you cannot see the complete installation.

Do anyone possibly have a picture, or drawing to share, or just an advice which screws/threads you recommend to use when fitting the block to an engine stand?


I normally use the flywheel flange for the Aluminium Alfa Twin Cams, but they are a lot lighter

#84
31-07-18, 22:25
We sorted it out the traditional way in the flywheel bell housing. Works just perfect. Case closed.