Steve Webb
06-11-11, 20:37
I thought I'd post this up as much as a reminder to myself as anything else.
Dragged the LSD out of the transaxle this afternoon, to take a look at what makes it tick and how worn it was.
This is where it comes out from. Dead easy to extract with the unit on the bench with everything disconnected.
http://www.berlinasportivo.com/forumpics/project75/housing.jpg
Once all the bolts are out, the cover comes off and the diff can just be pulled out.
First look at it on the bench and it looks in pretty good condition.
http://www.berlinasportivo.com/forumpics/project75/diff.jpg
The diff is opened up by jyst removing the ring of bolts on the top of the unit.
http://www.berlinasportivo.com/forumpics/project75/diff_top.jpg
Pulling it all apart, all the cross / clutch plates look to be in good condition and the thrust washers don't seem all that worn.
http://www.berlinasportivo.com/forumpics/project75/inner1.jpg
http://www.berlinasportivo.com/forumpics/project75/inner2.jpg
I've not checked the thickness of each plate, but I guess they are going to be thinner than they should be. I'll also be replacing 2 of the plates to get the 47% lockup as well.
Given that the thickness of the plates influences the amount of slip, I was wondering if the thickness of the thrust washer can also be used to get the desired amount of drag between the plates? It doesn't seem to be mentioned anywhere.
Dragged the LSD out of the transaxle this afternoon, to take a look at what makes it tick and how worn it was.
This is where it comes out from. Dead easy to extract with the unit on the bench with everything disconnected.
http://www.berlinasportivo.com/forumpics/project75/housing.jpg
Once all the bolts are out, the cover comes off and the diff can just be pulled out.
First look at it on the bench and it looks in pretty good condition.
http://www.berlinasportivo.com/forumpics/project75/diff.jpg
The diff is opened up by jyst removing the ring of bolts on the top of the unit.
http://www.berlinasportivo.com/forumpics/project75/diff_top.jpg
Pulling it all apart, all the cross / clutch plates look to be in good condition and the thrust washers don't seem all that worn.
http://www.berlinasportivo.com/forumpics/project75/inner1.jpg
http://www.berlinasportivo.com/forumpics/project75/inner2.jpg
I've not checked the thickness of each plate, but I guess they are going to be thinner than they should be. I'll also be replacing 2 of the plates to get the 47% lockup as well.
Given that the thickness of the plates influences the amount of slip, I was wondering if the thickness of the thrust washer can also be used to get the desired amount of drag between the plates? It doesn't seem to be mentioned anywhere.