jimnielsen
28-10-08, 05:14
After getting the car back from its weekend out at Winton - I have noticed that one of the cv boots on the front gearbox side drive shaft had split in half leaving a messy grease residue over everything - after i removed the driveshaft so that I could check the CV joint and replace the grease and boot, I noticed that the bearing in the front hub is a bit wobbly and a bit noisy - so I'd like to replace it.... in the manuals the best I can find is this diagram... but its not Q4 specific. Here also is a picture of the reverse side of the hub.
Is anybody familiar with the process of removing the front hub bearings..
looks like you have to remove the hub from the car, remove the circlip - that you can see in the pic .. but what next - do you then use a puller to pull the hub from the upright? or do you use a press to press the hub out from the circlip side? Looks like the bearing is a specific one - can you buy replacements at a local bearing shop or are they an alfa-only part?
hope i'm not the first to do this :(
jimn~
Is anybody familiar with the process of removing the front hub bearings..
looks like you have to remove the hub from the car, remove the circlip - that you can see in the pic .. but what next - do you then use a puller to pull the hub from the upright? or do you use a press to press the hub out from the circlip side? Looks like the bearing is a specific one - can you buy replacements at a local bearing shop or are they an alfa-only part?
hope i'm not the first to do this :(
jimn~