PDA

View Full Version : 1" cambelt kit.


Steve Webb
15-05-08, 21:10
I seem to remember reading about this 1" wide cambelt conversion a while ago. Just wondering if anyone has it fitted?
Juan AR155Q4
16-05-08, 02:42
It was a conversion using parts from a Fiat Ducato I think. I remember that countershaft belt should be removed.
Evodelta
16-05-08, 15:44
I bought one, the offset on the crank pulley is wrong which means the belt overhangs the camshaft pulleys, this means that whilst you have traded up to a bigger belt it's not much use if some of the extra width isn't being used and hanging over the edge.....

I had to re-engineer it all to make it work. If you are running standard or only mildly uprated cams then stick with OE, if you are running some wild profile cams on a serious engine then then the re-engineered kit is worth the money IMO.
T M Oren
16-05-08, 18:42
Ops!!!
I bougth this kitt.
Was it a big custom job to fitt the kitt???
Pictures?
155-tbo
17-05-08, 09:57
I have one set on my car.

Pictures:

http://i62.photobucket.com/albums/h88/AutonAlfa/Alfa%20rompetta/15122007006.jpg

http://i62.photobucket.com/albums/h88/AutonAlfa/Alfa%20rompetta/15122007007.jpg

http://i62.photobucket.com/albums/h88/AutonAlfa/Alfa%20rompetta/15122007008.jpg

http://i62.photobucket.com/albums/h88/AutonAlfa/Alfa%20rompetta/16122007002.jpg

http://i62.photobucket.com/albums/h88/AutonAlfa/Alfa%20rompetta/16122007.jpg

The belt goes out about 1-2 mm. I don`t do anything about that. Engine is still in working condition.
Engine support has some mild modification, otherwice your belt will hit on that support.
Evodelta
17-05-08, 16:43
This is what it looked like when I did a dry build:

http://i103.photobucket.com/albums/m127/Deltona_II/Engine/DSC00821.jpg

I turned the engine over a fair few times till it settled in, then I compared the new btm pulley with the old one and noted a 3mm difference which explained why it was doing this.
AlfaJack
17-05-08, 21:32
Does the original cambelt cover still fit over the pulleys?
T M Oren
18-05-08, 08:27
Did you remove the belt for the counterchafts?
Evodelta
18-05-08, 15:00
Did you remove the belt for the counterchafts?

Yes you have to, it won't fit with them.


As to whether the belt cover fits on a Q4 or not I don't know, you would hope so because without it you are skating on thin ice....
155-tbo
19-05-08, 16:40
Belt cover will fit. No problem.

Evodelta: I have the same problem with that belt line. It goes out about 1-2 mm. But it`s still better than old thin belt.
What was the difference between new and old btm pulley? 3mm, but where? has the new one 3 mm extra wide or what? How you re-engineer that parts? Do you have pictures after they were re-engineered?